Wire Tension Sensor 136.3-SCF-DC for measurement on thin pretensioned wires and ropes
• very small angle of material bending, therefore - no damage of the material - very low additional tension during measurement •Diameter Compensator for material diameters 0,1-5,5mm • available in 8 rated load ranges: 0 to 10N / 0 to 50N ULR - Ultra Low Range 0 to 100N / 0 to 500N LR - Low Range 0 to 1kN Standard 0 to 2kN / 0 to 3kN HR - High Range 0 to 4kN XR - Extended Range
Especially in Closed Force Systems (CFS) tension measurement with handheld sensors is extra critical and typically afflicted with a high, unforeseeable measuring error so far. Already a small change of the geometry in CFS causes a significant increase of tension. The unique conception of 136.3-SCF-DC fulfills this complicated measurement job. The typical measuring error is less than 1%. The sensor 136.3-SCF-DC first-time enables engineers precise measurements on thin wires and ropes even in CFS, with very easy handling: - thread the sensor - measure
The special design of the 136.3-SCF-DC sensor enables its use both in closed force systems and in running lines.
print
